top of page


Carter Johnson
Carter Johnson

Windows XP Professional With SP2 ISO, Pre-activated, And Key Inc Serial Key \/\/FREE\\\\

Windows XP featured a lot of new features that were relatively advanced in 2001 and subsequently Microsoft improved the OS by releasing new service packs. Well, service packs were a thing that used to exist and it was the earlier version of Windows update. Microsoft released several versions of Windows XP, to suit the requirements of different sets of people. They developed OSes for professional users, home users, and many more, so users with different needs can use the OS.

Windows XP Professional With SP2 ISO, Pre-activated, And Key Inc Serial Key

If this is from a big company with their logo on the OEM cd, you will need to use the recovery CD / DVD or method they provide to reinstall your Windows, and typically these are pre activated and do not need a serial key.

1) Wrong flavour of disk - IE an OEM key but a retail disk.2) Wrong flavour of windows. - IE an XP Home key but an XP Pro disk.3) Wrong Service pack level. - you can't use a key that was supplied with an XP including SP1 disk with an XP including SP2 disk.

One thing that I've run into is that the license key on the Dells we get is just a license. It doesn't activate windows at all, at least any of the versions I've tried. However, the Dell Windows install CDs are pre-pidded never prompt for a key. If you can, try to locate the original restore disks. While vendor specific, they are still fairly generic. A restore disc that came from that vendor with a different computer may also work.

What you get with this serial is the Pro version 4.0.1651 which came before SP1 and SP2, so you will not get the Pro features from these later versions. I have searched high and low but I cannot find serials for v4.0.4276.

What you need is a pre SP1 version that can be activated with a serial then upgrade to SP2 using version 4.0.4376. The version 4.0.1651 supplied free by Microsoft is pre-activated, so that it cannot be upgraded.

Measurements of water vapor absorption were taken with a resonant optoacoustical detector (cylindrical pyrex detector, two BaF2 windows fitted into end plates at slight tilt to suppress Fabry-Perot resonances), for lack of confidence in existing spectral tabular data for the 5-7 micron region, as line shapes in the wing regions of water vapor lines are difficult to characterize. The measurements are required for air pollution studies using a CO laser, to find the differential absorption at the wavelengths in question due to atmospheric constituents other than water vapor. The design and performance of the optoacoustical detector are presented. Effects of absorption by ambient NO are considered, and the fixed-frequency discretely tunable CO laser is found suitable for monitoring urban NO concentrations in a fairly dry climate, using the water vapor absorption data obtained in the study.

The interaction of sunlight with atmospheric gases, aerosols and clouds is fundamental to the understanding of climate and its variation. Several studies questioned our understanding of atmospheric absorption of sunlight in cloudy or in cloud free atmospheres. Uncertainty in instruments' accuracy and in the analysis methods makes this problem difficult to resolve. Here we use several years of measurements of sky and sun spectral brightness by selected instruments of the Aerosol Robotic Network (AERONET), that have known and high measurement accuracy. The measurements taken in several locations around the world show that in the atmospheric windows 0.44, 0.06, 0.86 and 1.02 microns the only significant absorbers in cloud free atmosphere is aerosol and ozone. This conclusions is reached using a method developed to distinguish between absorption associated with the presence of aerosol and absorption that is not related to the presence of aerosol. Non-aerosol absorption, defined as spectrally independent or smoothly variable, was found to have an optical thickness smaller than 0.002 corresponding to absorption of sunlight less than 1W/sq m, or essentially zero.

An infrared absorption cell has been developed which is suitable for high temperature liquids which have absorptions in the range .1-10('3) cm('-1). The cell is constructed by clamping a gasket between two flat optical windows. This unique design allows the use of any optical windows chemically compatible with the liquid. The long -wavelength limit of the measurements is therefore limited only by the choice of the optical windows. The thickness of the cell can easily be set during assembly, and can be varied from 50 (mu)m to .5 cm. Measurements of the optical absorption edge were performed on the liquid alloy Se(,1-x)Tl(,x) for x = 0, .001, .002, .003, .005, .007, and .009, from the melting point up to 475(DEGREES)C. The absorption was found to be exponential in the photon energy over the experimental range from 0.3 eV to 1.2 eV. The absorption increased linearly with concentration according to the empirical relation (alpha)(,T)(h(nu)) = (alpha)(,1) + (alpha)(,2)x, and the absorption (alpha)(,1) was interpreted as the absorption in the absence of T1. (alpha)(,1) also agreed with the measured absorption in 100% Se at corresponding temperatures and energies. The excess absorption defined by (DELTA)(alpha) = (alpha)(,T)(h(nu))-(alpha)(,1) was interpreted as the absorption associated with Tl and was found to be thermally activated with an activation energy E(,t) = 0.5 eV. The exponential edge is explained as absorption on atoms immersed in strong electric fields surrounding ions. The strong fields give rise to an absorption tail similar to the Franz-Keldysh effect. A simple calculation is performed which is based on the Dow-Redfield theory of absorption in an electric field with excitonic effects included. The excess absorption at low photon energies is proportional to the square of the concentration of ions, which are proposed to exist in the liquid according to the relation C(,i) (PROPORTIONAL) x(' 1/2)(.)e('-E)t('/kT), which is the origin of the thermal activation

When, if ever, should psychological scientists be permitted to offer professional opinions concerning the mental health of public figures they have never directly examined? This contentious question, which attracted widespread public attention during the 1964 U.S. presidential election involving Barry Goldwater, received renewed scrutiny during and after the 2016 U.S. presidential campaign, when many mental health professionals raised pointed questions concerning the psychiatric status of Donald Trump. Although the Goldwater Rule prohibits psychiatrists from offering diagnostic opinions on individuals they have never examined, no comparable rule exists for psychologists. We contend that, owing largely to the Goldwater Rule's origins in psychiatry, a substantial body of psychological research on assessment and clinical judgment, including work on the questionable validity of unstructured interviews, the psychology of cognitive biases, and the validity of informant reports and of L (lifetime) data, has been overlooked in discussions of its merits. We conclude that although the Goldwater Rule may have been defensible several decades ago, it is outdated and premised on dubious scientific assumptions. We further contend that there are select cases in which psychological scientists with suitable expertise may harbor a "duty to inform," allowing them to offer informed opinions concerning public figures' mental health with appropriate caveats. 350c69d7ab




  • Jawad Hossain
    Jawad Hossain
  • Shafiul Azom
    Shafiul Azom
  • Ibrahim Somrat
    Ibrahim Somrat
  • Carrie Clark
bottom of page